📌 Purpose
- Provides an operational guide for the learning technology in O'Hare 160 (Bazarsky).
👥 Audience
🖥️ Applies To
🛠️ Instructions
To begin, press anywhere on the touch panel splash page.
Press which source you would like to display on the projector. Once a selection is made, it takes about 30 seconds for the projector to fully display.
"Room Computer" refers to the computer inside the lectern podium. Make sure the labelled power button is on.
Plug your laptop into the provided HDMI cable to use the "laptop" selection.
The "Side Lectern" option is not needed for daily use. To use this option, contact the Technology Services Center with the contact information at the bottom of this article to set up an appointment.
[NOTE* There has been a delay in installation of Air Media in this room. This section is for future use.] Air Media works with your laptop in two ways. Plug the Air Media adapter into a USB-C port on your device. Select "Air Media" on the touch panel and your device will display after a few seconds.
You can also type the IP address in the lower left of the Air Media home screen into the address bar of a browser, and access Air Media connectivity without the adapter. Follow the prompts once the IP brings you to the home page.
The "clear" button will remove all sources from the projection.
To use the camera installed in the room for remote/hybrid classes and meetings, select the "camera" icon in the upper right of the touch panel.
If using the room computer for your meeting, make sure the "USB to PC" button is selected.
To use the camera/microphones for your meeting from your own laptop, plug the provided USB cable into your laptop and make sure "USB to Laptop" is selected.
Use the directional arrows and +/- magnifying glasses to rearrange the angle of the camera. Presets 1, 2, and 3 offer close up, medium, and wide angles.
The speech volume area is for increasing the volume of the microphones in the room. To adjust your sound for a remote meeting, do so in the meeting software settings.
The program volume controls the audio signal coming from the selected room computer or laptop.
The "power" icon in the upper right of the touch panel leads you to the system shut down page.
Please shut the system down when you are done using the room!
💡 Troubleshooting & Tips
- To use the handheld and lavalier microphones normally kept in the booth, contact the TSC.
- Contact the Technology Services Center help desk for assistance: (401) 341-7777. support@salve.edu